Pages

June 22, 2010

Oh, how deepwater oil drilling can go wrong

With the help of the New York Times, let us count the ways it DID go wrong with Deepwater Horizon, and could go wrong again in the future, unless President Obama actually does something during the drilling moratorium. (That said, as you read further down this long, quote-heavy post, and click the story link for more detail, you may not want to hold your breath over too much "does something" happening.

As it turns out, records and interviews show, blind shear rams can be surprisingly vulnerable. There are many ways for them to fail, some unavoidable, some exacerbated by the stunning water depths at which oil companies have begun to explore.

But they also can be rendered powerless by the failure of a single part, a point underscored in a confidential report that scrutinized the reliability of the Deepwater Horizon’s blowout preventer. The report, from 2000, concluded that the greatest vulnerability by far on the entire blowout preventer was one of the small shuttle valves leading to the blind shear ram. If this valve jammed or leaked, the report warned, the ram’s blades would not budge.

This sort of “single-point failure” figures prominently in an emerging theory of what went wrong with the Deepwater Horizon’s blind shear ram, according to interviews and documents. Some evidence suggests that when the crew activated the blind shear ram, its blades tried to cut the drill pipe, but then failed to finish the job because one or more of its shuttle valves leaked hydraulic fluid.

These kinds of weaknesses were understood inside the oil industry, documents and interviews show. And given the critical importance of the blind shear ram, offshore drillers began adding a layer of redundancy by equipping their blowout preventers with two blind shear rams.

So, it appears, again, that some of this is BP's fault, not Big Oil's fault. But, some of it is Big Oil in general:
Last year, Transocean commissioned a “strictly confidential” study of the reliability of blowout preventers used by deepwater rigs.

Using the world’s most authoritative database of oil rig accidents, a Norwegian company, Det Norske Veritas, focused on some 15,000 wells drilled off North America and in the North Sea from 1980 to 2006.

It found 11 cases where crews on deepwater rigs had lost control of their wells and then activated blowout preventers to prevent a spill. In only six of those cases were the wells brought under control, leading the researchers to conclude that in actual practice, blowout preventers used by deepwater rigs had a “failure” rate of 45 percent.

For all their confident pronouncements about blowout preventers (the “ultimate failsafe device,” some called it), oil industry executives had long known they could be vulnerable and temperamental.

Rising five or more floors and weighing hundreds of thousands of pounds, these devices were daunting in their scale and complexity. There were hundreds of ways they could malfunction or be improperly maintained, tested and operated. Not only did they have to withstand extreme environments, they were relied upon to tame the ferocious forces often unleashed when drilling rigs penetrate reservoirs of highly compressed oil and gas.

They were also costly to maintain. An industry study last year estimated the price of stopping operations to pull up a blowout preventer for repairs at $700 per minute.

Those costs could be enough to draw the attention of Wall Street.

Ahh, the old bottom line. That said, some industries accept more regulatory costs, or trade on a safety reputation as part of their bottom-line enhancement. Given that BP's safety record was so crappy under Tony Hayward's predecessor, Lord Browne, one wonders if he ever thought of that idea.

And that's not all:
>>In 1990, a blind shear ram could not snuff out a major blowout on a rig off Texas. It cut the pipe, but investigators found that the sealing mechanism was damaged. And in 1997, a blind shear ram was unable to slice through a thick joint connecting two sections of drill pipe during a blowout of a deep oil and gas well off the Louisiana coast. ...

(And) in two studies, in 2002 and 2004, one of the industry’s premier authorities on blowout preventers, West Engineering Services of Brookshire, Tex., found a more basic problem: even when everything worked right, some blind shear rams still failed to cut pipe.

West’s experts concluded that calculations used by makers of blowout preventers overestimated the cutting ability of blind shear rams, so-called because they close off wells like a window blind. Modern drill pipe is nearly twice as strong as older pipes of the same size. In addition, the intense pressure and frigid temperatures of deep water make it tougher to shear a pipe. These and other “additive pressures,” the researchers found, can demand hundreds of thousands of additional pounds of cutting force.



Yet when the team examined the performance of blind shear rams in blowout preventers on 14 new rigs, it found that seven had never been checked to see if their shear rams would work in deep water. Of the remaining seven, only three “were found able to shear pipe at their maximum rated water depths.”<<


And, the feds are at fault, too:
>>In 2001, just as BP and Transocean were pressing the Deepwater Horizon into service, the Minerals Management Service was being warned against allowing deepwater rigs to operate with only one blind shear ram. The agency had commissioned a study that documented more than 100 failures during testing of blowout preventers.



“All subsea B.O.P. stacks used for deepwater drilling should be equipped with two blind shear rams,” said the report, written by the SINTEF Group, a Scandinavian research organization that advises the oil industry and maintains detailed records on blowouts around the world.



The agency made no such requirement. Indeed, it waited until 2003 to require even one blind shear ram. By then, the industry had already started moving to two blind shear rams — although industry and government records show that roughly two-thirds of the rigs in the gulf today still have only one.<<
And, THAT is scary. Why, during the deepwater drilling moratorium, isn't Minerals MISmanagement Service requiring all deepwater rigs with just one ram to be retrofitted? Salazar, the story, notes has "recommended" such rules, but that's it. Equally scary is no testing requirements for backups like the deadman and autoshear. And, again, why isn't MMS promulgating new regs to this end during the moratorium?



Ultimately, it's a legacy of Reaganism + Newtism, combined with Clinton's natural neoliberalism, shifting Democrats far enough right that Barack Obama can talk about admiring Reagan.


That, in turn, leads to lies like this from Team Obama:
Barely three weeks before the Deepwater Horizon disaster, President Obama announced that he planned to open vast new tracts of ocean for oil exploration, including environmentally sensitive areas that for decades had been declared off limits by presidents from both parties.

Environmental groups were bitterly disappointed, but Mr. Obama said he had arrived at his decision after more than a year of study by his administration, including a careful weighing of environmental risks. Yet the administration’s examination did not question the oil industry’s confident assertions about its drilling technology. The well-known weaknesses of blowout preventers and blind shear rams simply did not make it onto the administration’s radar, interviews and documents show.

Mr. Hayes, the deputy interior secretary, said senior officials were reassured, perhaps wrongly, by “the NASA kind of fervor” over the oil industry’s seemingly “terrific technology.” They took comfort in what appeared to be a comprehensive regime of regulations. Most of all, he said, they were impressed by the rarity of significant oil spills even as more of the nation’s domestic oil supply was being drawn from ultradeep wells.

“The track record was good,” he said. “The results were significant.”

Not even environmental groups bitterly opposed to expanding offshore drilling were raising concerns about the industry’s technology for preventing deepwater spills, he added. “We were not being drawn by anybody to a potential issue with deepwater drilling or blowout preventers.”

Untrue. While not getting into every detail, non-Gang Green enviro groups have long worried about whether Big Oil could deliver.

No comments:

Post a Comment

Your comments are appreciated, as is at least a modicum of politeness.
Comments are moderated, so yours may not appear immediately.
Due to various forms of spamming, comments with professional websites, not your personal website or blog, may be rejected.